User guide

► To activate the Preset WD:

Press “95” + hold the [PRESET] key for 2 seconds to enter the main menu

screen.

Move the cursor to <PRESET SETUP>, and then press the [OPEN] key <PRESET

SETUP> menu.

Move the cursor to the PRESET WD selection and then press the [OPEN] key.

Move the joystick up/down to choose the position(P0~66), and left/right to set

OFF, BLC, or WDR.

Press the [OPEN] key to confirm the selection or press the [CLOSE] key to

cancel selection and exit from the menu screen.

Preset Motion (For WDR model only)

<PRESET SETUP> → <PRESET MOTION> → PRESET MOTION

User can enable motion function for individual preset points. You can create and

move up to 4 motion areas for every individual present point.

NotePRESET MOTION function only support certain models and support

P0~P10 preset point only.

► To activate the Preset motion:

Press “95” + hold the [PRESET] key for 2 seconds to enter the main menu

screen.

Move the cursor to <PRESET SETUP>, and then press the [OPEN] key <PRESET

SETUP> menu.

Move the cursor to the PRESET MOTION selection and then press the [OPEN]

key.

Move the joystick up/down to choose the position(P0~10), and left/right to set

ON, or OFF.

Move the cursor to the MOTION AREA selection and then press the [OPEN] key.

Press the [OPEN] key to confirm the zone #, and then move zone. Screen

display: MOTION AREA 1 MOVE

Press the [OPEN] key to confirm the zone #, and then go to the setup screen for

the zone size:

Screen display: MOTION AREA 1 SIZE

Move the joystick up/down to set the zone size.

press the [CLOSE] key to exit from the menu screen.

Move the joystick up/down to choose the threshold LEVEL selection, and

left/right to set HI, MID or LOW.

Move the joystick up/down to choose the INTERCAL TIME selection, and

left/right to set the time.

Preset Motion (For WDR model only)