User guide

You can modify individual preset speed for individual preset points. When

setting “MAX” SPEED in preset speed section, the speed is depended on the

setting in SCAN SPEED

► To activate the Preset speed:

1. Press “95” + hold the [PRESET] key for 2 seconds to enter the main menu

screen.

2. Move the cursor to <PRESET SETUP>, and then press the [OPEN] key

<PRESET SETUP> menu.

3. Move the cursor to the PRESET SPEED selection and then press the [OPEN]

key.

4. Move the joystick up/down to choose the position, and left/right to set

preset speed.

5. Press the [OPEN] key to confirm the selection or press the [CLOSE] key to

cancel selection and exit from the menu screen.

Title

<PRESET SETUP> → <TITLE> → PRESET TITLE INPUT

► To activate the Tilte:

Press “95” + hold the [PRESET] key for 2 seconds to enter the main menu

screen.

Move the cursor to <PRESET SETUP>, and then press the [OPEN] key <PRESET

SETUP> menu.

Move the cursor to the TITLE selection and then press the [OPEN] key.

Enter TITLE menu then move the joystick up/down to select the preset point.

Move the cursor to the right to enter the title input field. Use the joystick

up/down to select the character, and then move the cursor left/right to the next

character.

Move the cursor down to the TITLE POSITION, and then press the key to select

either the UP or DOWN position. UP will show the title at top of the screen, and

DOWN will show the title at bottom of the screen.

Preset WD (For WDR model only)

<PRESET SETUP> → PRESET WD

You can enable WDR function for individual preset point.

NotePRESET WD function only support certain models and support P0~P66

preset point only.

Chapter 4: Configuring the Nextiva S5500 PTZ Series Properties