User guide

[OPEN] key.

4. Move the joystick up/down to choose ON or OFF.

5. Press the [OPEN] key to confirm the selection or press the [CLOSE] key to

cancel selection and exit from the menu screen.

► To set Set the Manual Scan Range:

1. Activate the manual scan range (MANUAL LIMIT STOP = ON) and then exit

the menu.

2. Set the left limit: use the joystick and move the camera to the left limit

position, then press number key “90” + hold the key for 2 seconds. The

screen will show: MANUAL LEFT LIMIT, and the left limit will be set.

3. Set the right limit: use the joystick and move the camera to the right limit

position, then press number key “91” + hold the key for 2 seconds. The

screen will show: MANUAL RIGHT LIMIT, and the right limit will be set.

Setting Recover Time

<PAN/TILT SETUP> → RECOVER TIME

Under scan mode (auto, frame, random), if the auto patrol and pattern patrol

are interrupted from inadvertent keypad controller input, the camera will

resume the previous action after a set amount of time. The recovery time can

be configured from 1 to 120 min, and can be disabled (OFF).

► To set the Recovery Time:

1. Press “95” + hold the [PRESET] key for 2 seconds to enter the main menu

screen.

2. Move the cursor to <PAN/TILT SETUP>, and then press the [OPEN] key

<PAN/TILT SETUP> menu.

3. Move the cursor to the RECOVER TIME selection and then press the [OPEN]

key.

4. Move the joystick up/down to set the time.

5. Press the [OPEN] key to confirm the selection or press the [CLOSE] key to

cancel selection and exit from the menu screen.

Setting Scan Speed

<PAN/TILT SETUP> → SCAN SPEED

Auto, random, and frame scan speed can be configured between 1° ~ 90° /sec,

but cannot exceed the MAX SPEED setting.

Chapter 4: Configuring the Nextiva S5500 PTZ Series Properties