User guide

Setting Scan Range

<PAN/TILT SETUP> → SCAN LIMIT STOPS

When the camera scan mode is set to random, frame, or auto, once the scan

range is reached, the camera will turn the other direction.

► To activate a scan range:

1. Press “95” + hold the [PRESET] key for 2 seconds to enter the main menu

screen.

2. Move the cursor to <PAN/TILT SETUP>, and then press the [OPEN] key

<PAN/TILT SETUP> menu.

3. Move the cursor to the SCAN LIMIT STOPS selection and then press the [OPEN]

key.

4. Move the joystick up/down to choose ON or OFF.

5. Press the [OPEN] key to confirm the selection or press the [CLOSE] key to

cancel selection and exit from the menu screen.

► To Set the Scan Range:

1. Activate the scan range (SCAN LIMIT STOP = ON) and then exit the menu.

2. Set the left limit: use the joystick and move the camera to the left limit

position, then press number key “92” + hold the key for 2 seconds. The

screen will show: SCAN LEFT LIMIT, and the left limit will be set.

3. Set the right limit: use the joystick and move the camera to the right limit

position, then press number key “93” + hold the key for 2 seconds. The

screen will show: SCAN RIGHT LIMIT, and the right limit will be set.

Setting Manual Scan Range

<PAN/TILT SETUP> → MANUAL LIMIT STOPS

When using the joystick to control the horizontal panning, the camera will stop

panning once it reaches the MANUAL LIMIT STOPS. The scan limit can be

configured as left and right limit.

► Activate the Manual Scan Range:

1. Press “95” + hold the [PRESET] key for 2 seconds to enter the main menu

screen.

2. Move the cursor to <PAN/TILT SETUP>, and then press the [OPEN] key

3. Move the cursor to the MANUAL LIMIT STOPS selection and then press the

Setting Scan Range