User guide

ACTIONS> then press the [OPEN] key the <ALARM ACTIOS> menu.

4. Move the cursor to the alarm input, and configure the preset action and

alarm output status (ON or OFF).

5. Alarm DELAY TIME: The alarm delay time can be configured (5~120 sec).

The diagram below explains the alarm action from the signal:

1. Positive edge triggered.

2. If there are new alarms triggered during an existing alarm, then the first

alarm will be invalid.

3. After the alarm ends, the camera will continue with the action before the

alarm is triggered.

When using the infrared projector

When using the infrared illuminations during nighttime as an auxiliary light

source, the infrared activation signal can be connected to the alarm input port

and set the alarm action to BW mode. This will prevent the constant switching

between color and monochrome images caused by the strength of the external

light source, as well as improve sensitivity and avoid image shaking.

Motion Detection

The camera features motion detection capabilities and is similarly configured

as the alarm setup.

Note

Motion function is selectable: BW/Preset point/OFF action. When camera set in

Path action, the camera would track the moving objective (For WDR model

only).

When using the infrared projector