User guide

► To Set Privacy Zone Size and Position using the keypad controller:

1. First move the image to be masked to the center of the screen.

2. Press number key “83” then press and hold the key for 2 seconds to go to

the setup screen for the zone #: Screen display: PRIVACY ZONE 1 Move the

joystick up/down to select the zone #

3. Press the [OPEN] key to confirm the zone #, and then go to the setup screen

for the zone size: Screen display: PRIVACY ZONE SIZE, Move the joystick

up/down to set the zone size.

4. Press the [OPEN] key to confirm the zone size, and then go to the setup

screen for the zone color: Screen display: PRIVACY ZONE COLOR Move the

joystick up/down to select the zone color (black or white).

5. Press the [OPEN] key to confirm the zone color and then go to the next zone

setting step, or press the [CLOSE] key to exit the privacy zone setup mode.

Note

1. Up to 24 zones can be setup, but the screen can simultaneously display 8

zones.

2. It is recommended to set the privacy zone slightly larger than the actual

area, to ensure that privacy area is not revealed during movement.

3. Privacy zone will zoom with the lens zoom level to ensure the effect.

Alarm Action

<CAMERA SETUP> → ALARM ACTIONS

There are a set of alarm ports under the camera including 6 alarm inputs and 1

alarm output. Each alarm can be configured with 256 preset action point, and

when alarm 1~6 is triggered, the camera will immediately move to the

predefined position.

Note

These alarms are not visible to Nextiva VMS.

► To set the Alarm Action:

1. Press “95” + hold the [PRESET] key for 2 seconds to enter the main menu

screen.

2. Move the cursor to <CAMERA SETUP>, and then press the [OPEN] key

<CAMERA SETUP> menu.

3. Before entering the <ALARM ACTIONS> screen, please first use the keypad

controller to set the preset action point (press number key + key at least 2

seconds and up to 256 points) and then move the cursor to <ALARM

Chapter 4: Configuring the Nextiva S5500 PTZ Series Properties