User guide

During startup, the camera will perform vertical scanning from the tilt angle

setting. For configuring the tilt angle, please use the menu command

<OTHERS> SCAN TILT ANGLE. When the keypad controller issues auto-

scanning command, the tilt angle will remain at the original setting.

Frame Scanning:

Frame scanning can be configured to run at startup, or can be controlled by the

keypad controller (refer to the table in Chapter 8). Configuring the zoom level

and tilt angle is the same as in auto scanning.

(a). When the scan range has not been set:

The camera will scan at 45° increments until a command from the keypad

controller is received (e.g. horizontal rotate, vertical rotate, iris, and focus

etc.) Please refer to the diagram below.

Random Scanning:

Random scanning can be configure to run at startup, or can be controlled by the

keypad controller. Configuring the zoom level and tilt angle is same as in auto

scanning.

(a). When the scan range has been set: (figure.1)

The camera will randomly pick a stop point and perform scanning until a

command from the keypad controller is received (e.g. horizontal rotate,

vertical rotate, iris, and focus etc.) Please refer to the diagram below.

(b). When the scan range has been set: (figure.2)

The camera will randomly pick a stop point and perform scanning in the scan

range until a command from the keypad controller is received (e.g. horizontal

rotate, vertical rotate, iris, and focus etc.)

Note

Use the menu command <PAN/TILT SETUP> STOP TIME (P0) to configure the

stop time, range from 5 sec to 120 sec.

Chapter 4: Configuring the Nextiva S5500 PTZ Series Properties