User guide

Using the Horizontal Pan and Vertical Tilt

Manual horizontal pan must be controlled through the joystick on the keypad

controller. The rotation speed is adjustable between 0.1°~90°/sec by the

position of the joystick, and up to

150°/sec under Turbo mode. The speed is restricted when using Proportion P/T

mode.

Manual vertical tilt speed is adjustable between 0.1°~45°/sec, and the speed

will be restricted when under Proportion P/T mode.

Horizontal pan range 360°continuous rotation

Vertical tilt range 92°

Manual horizontal pan speed 0.1°~90°/s

Manual horizontal pan speed

(Turbo mode, Pelco P/Messoa-P

only)

150°/s

Manual vertical tilt speed 0.1°~45°/s

Preset maximum rotation speed Horizontal:430°/s

Vertical:200°/s

Note

In an indoor environment, the maximum tilt angle is 85° degree and

maximum 92° for an outdoor environment.

Using the Scanning Mode

Auto Scan:

Auto scan can be configured to run at startup, or can be controlled by the

keypad controller.

(a). When the scan range has not been set:

The camera will rotate horizontally until a command from the keypad controller

is received (e.g. horizontal rotate, vertical rotate, IRIS, and focus etc.)

(b). When the san range has been set:

The camera will rotate horizontally in the scan range until a command from the

keypad controller is received (e.g. horizontal rotate, vertical rotate, iris, and

focus etc.) For configuring the scan range, please use the menu command

<PAN/TILT SETUP> SCAN LIMIT STOPS.

(c). Lens zoom:

During startup, the lens will zoom out and auto scanning will remain at the

original zoom level.

(d). Tilt angle:

Using the Horizontal Pan and Vertical Tilt