User guide

Powering the Nextiva S5500 PTZ Series

Use the following procedure to power the Nextiva S5500 PTZ Series using a 24V

AC for power.

Note

The Nextiva S5503PTZ-18ID requires 18W and the Nextiva S5503PTZ-28DW

and S5503PTZ-36DW requires 46W (With a high-speed dome camera: 20W,

with a heater: 26W)

► To power the Nextiva S5500 PTZ Series using a 24V AC power

supply:

1. Connect the wires (Black and White) from the camera to the terminal block.

2. Connect the ground wire (Green) to a proper electrical ground.

3. Connect the wires from the power supply to the terminal block.

4. Plug the power supply cable to the power outlet.

Connecting the Nextiva S5500 PTZ Series

to the Network

Use the following procedure to connect the Nextiva S5500 PTZ Series to the

network.

► To connect the Nextiva S5500 PTZ Series to the network:

1. Connect the RJ45 male connector to the RJ45 coupler.

2. Connect an ethernet cable into the RJ45 coupler.

Chapter 2: Installing the Nextiva S5500 PTZ series