User guide

Note

If you are using a water sealant, you must cover the entire portion of the

spiral tooth of the connector ring with the sealant. This will prevent rain

water leaking through the connection.

7. Thread the cabling of the main unit through the short aluminum tube and the

wall hang support.

8. Push the cables out from the bottom of the support.

9. Pull out the cables and connect the main unit to the connector ring in the

clockwise direction.

10. Use a hex driver to secure the stop screw to the connector ring and fasten

the safety cable to the wall.

Chapter 2: Installing the Nextiva S5500 PTZ series