User guide

7. Thread the cabling of the main unit through the short aluminum tube and the

wall hang support.

8. Push the cables out from the bottom of the support.

9. Pull out the cables and connect the main unit to the connector ring in the

clockwise direction.

10. Use a hex driver to secure the stop screw to the connector ring and fasten

the safety cable to the wall.

11. Attach the dome cover to the camera.

► To install the Nextiva S5500 PTZ Outdoor IP Cameras on a pendant pipe:

1. Remove the dome cover from the PTZ camera using the supplied

screwdriver.

2. Remove the lens cover and the foam protector.

3. Remove the connector ring (Female pipe thread G1-1/2) from the PTZ

Chapter 2: Installing the Nextiva S5500 PTZ series