User guide

► To set a DHCPaddress

1. Start the Web Interface.

2. From the tree, select Configuration >Network.

3. In the Hostname box, type a unique name for the Edge device.

4. In the Default Gateway box, type the IP address of the server that acts as

an access point to another network. You can obtain the IP address of the

default gateway by asking the network administrator.

Note

You do not need to use a gateway if the device communicates with other Edge

devices on the same subnet.

5. In the MTU box, type largest protocol data unit that the layer can pass

onwards.

6. In the Web Server Port box, type the http port number to use as an access

point to the internet. The default value is 80.

Chapter 5: Using the Web Interface for Configuration