User guide

Setting the Audio Encoder Properties

The S1801e, S1802e, S1808e-A and S1816e-A supports bi-directional audio:

audio input and output. Audio input allows you to capture audio signals from a

camera, provided that it supports audio, at the same time it captures video.

► To set the audio encoder properties

1. Start SConfigurator.

2. Select the Units tab, then click Discover.

3. Select the Nextiva device, and click Configure.

4. In the tree view, click Unit >Audio >Encoder.

5. Select an Encoder to configure.

6. Set the value for the following settings:

Input Type: Select Line-in or Mic (with pre-amp).

Input Compression: Select Uncompressed PCM (128 kbps) or μ-LAW

(64 kbps).

Gain State: Select Enabled or Disabled.

Gain Level: Move the slider to the left or right.

Bias State: Select Enabled or Disabled.

Bias Level: Move the slider to the left or right.

7. Click OK.

Chapter 4: Using SConfigurator for Configuration