User guide

► To set the SNMPproperties

1. Start SConfigurator.

2. Select the Units tab, then click Discover.

3. Select the Nextiva device, and click Configure.

4. In the Units box, right-click the S1800e device, then select Batch

Network Configuration.

5. In the SNMP panel, select the Enabled check box enable the SNMP service.

6. In the System Location box, type the location for the Edge device.

7. In the System Contact box, type the e-mail address of the network

administrator.

8. In the Primary Trap Destination Address box, type the IP address of the

primary server that will receive the SNMP Traps.

9. In the Backup Trap Destination Address box, type the IP address of the

backup server that will receive the SNMP Traps in case the primary server is

unavailable.

Setting the SNMP Properties