User guide

8. In the Stop bits list, select the stop bits used by the serial equipment. Stop

bits let the receiver know that the byte being transmitted has ended.

9. In the Data bits list, select the data bits used by the serial equipment. Data

bits represents the number of bits in each data that is sent over the

network. Eight data bits are universally used in most applications.

10. (Single- and Dual-Port devices)In the Operation Mode, select the way the

serial equipment interfaces with the device.

11. Click OK to close the Unit Configuration dialog box.

12. Click Exit.

Setting the H.264 Encoding Mode for the

S1816e-SP or S1816e-SR

The S1816e--SP and S1816e-SR supports H.264 and MPEG-4 video on all 16

ports and can be configured in dual or triple stream modes. By default, the

S1816e-SP is set to dual stream mode consisting of a single high-performance

H.264 stream and a single MPEG-4 stream per video input. However, you can

set it to triple stream mode consisting of two H.264 streams with lower

resolution and framerate and a single MPEG-4 stream per video input.

Chapter 4: Using SConfigurator for Configuration