User guide

8. In the Stop bits list, select the stop bits used by the serial equipment. Stop

bits let the receiver know that the byte being transmitted has ended.

9. In the Data bits list, select the data bits used by the serial equipment. Data

bits represents the number of bits in each data that is sent over the

network. Eight data bits are universally used in most applications.

10. (Single- and Dual-Port devices)In the Operation Mode, select the way the

serial equipment interfaces with the device.

11. Click OK to close the Unit Configuration dialog box.

12. Click Exit.

Configuring the RS-422/485 Serial Port

Using SConfigurator

Use the following procedure to configure the RS-422/485 port using

SConfigurator.

Chapter 4: Using SConfigurator for Configuration