User guide

Powering the Multiport Devices

You can use the PS1261 or any other certified power supply to connect to the

S1800e series devices. If you plan on using a power supply other than the

PS1261, ensure that it is certified with an output voltage rating of 12V DC and

an output current rating of 1.8A up to 3A. The power wire gauge should be in

the wire range of 28-16 AWG in order to properly engage the terminal block

plug.

► To power the devices

1. Remove the terminal block plug from the rear of the device.

2. Verify the polarity of each wire from the power supply according to the

attached label.

3. Connect the positive power wire in the corresponding +12V pole and the

negative power wire in the corresponding GND pole on the terminal block

plug and screw them into place using 1.7 in-lb (0.19 N-m) force.

4. Connect the terminal block plug to the on the rear of the device.

Powering the Multiport Devices