User guide

Powering the S1801e-POE

The S1801e and S1802e encoders consumes up to 5W of power, while the

S1801e-R and S1801e-R-HDMI consumes up to 4W of power.

► To power the S8101e-POE

1. Plug a straight-through Ethernet cable into the LAN 10/100 (RJ-45)

connector on the back of the S1801e-POE encoder.

2. Plug the other end of the cable into a POE Ethernet switch or to the

Data&PWR port of a POE injector. If you use a PoE injector, make sure the

Data port of the injector is properly connected to the Ethernet switch.

Connecting Analog Cameras

The following procedure describes how to connect analog cameras directly to

the device.

Powering the S1801e-POE