User guide

► To power the devices

1. Remove the terminal block plug from the rear of the device.

2. Verify the polarity of each wire from the power supply according to the

attached label.

3. Connect the positive power wire in the corresponding +12V pole and the

negative power wire in the corresponding GND pole on the terminal block

plug.

4. Connect the terminal block plug to the on the rear of the device.

5. Connect the power supply to an outlet or UPS.

6. If required, connect the serial ports of the S1800e device to a PTZ camera.

Chapter 2: Installing the Single-and Dual-Port Devices