User guide

Performing a Batch Firmware Update

With the Nextiva video management software, you can easily update the

firmware for multiple devices in the environment at the same time rather than

updating them individually. For more information, refer to the Nextiva

documentation.

Device Reboot

If the S1800e device does not function the way it should, you can reboot the

device to re-initialize the settings. To reboot the device using a video

management software, refer to the user guide for instructions.

Rebooting the Device Using SConfigurator

Use the following procedure to reboot the device using SConfigurator.

► To reboot using SConfigurator

1. Start SConfigurator.

2. Select the Units tab, then click Discover.

3. Select the device, and click Reboot.

4. Click OK.

Rebooting the Edge Device

Rebooting the devices allows you to re-initialize the settings or apply the new

parameters. If you change a parameter that requires a reboot and decline to

reboot the Edge device immediately, the icon will flash red until the Edge

device is rebooted. To reboot the device using a video management software,

refer to the user guide for instructions.

► To reboot using the Web Interface

1. Start the Web Interface.

From the Quick Launch bar, click .

Rebooting the Device from the Front Panel

Use the following procedure to reboot the device from the front panel.

Performing a Batch Firmware Update