User guide

► To set the SNMPproperties

1. Start the Web Interface.

2. From the tree, select Configuration >SNMP.

3. In the SNMP panel, select the Enabled check box enable the SNMP service.

4. In the System Location box, type the location for the Edge device.

5. In the System Contact box, type the e-mail address of the network

administrator.

6. In the Primary Trap Destination Address box, type the IP address of the

primary server that will receive the SNMP Traps.

7. In the Backup Trap Destination Address box, type the IP address of the

backup server that will receive the SNMP Traps in case the primary server is

unavailable.

8. In the Community Name box, type the name of the group where you want

the edge device to be a member.

Note

The Edge device will only respond to requests from management servers that

belong to the same community.

9. In the User Name box, type the name of the SNMP user.

Setting the SNMP Properties