User guide

7. OntheRecorder Settingspage,clickNext.

8. OntheSummary of Changespage,reviewthemodificationsand,if

required,clickBack tomakecorrectionsorCanceltoexitthewizard

withoutapplyinganyofthemodifications.

9. ClickFinish.

10. ClickDone.

Adding the HDR 1800 Manually

TheHDR1800maynotappearinthelistofdiscovereddevices.Inthatcase,

youmustperformamanualdevicediscovery.

Note

DevicesthatareinstalledunderadifferentsubnetdonotappearintheNew

Componentspane.

Whenaddingadevicemanually,youneedtospecifyanIPaddressorrange,

thedevicemanufacturer,andtheconnectionsettings.

► To add the HDR 1800 manually

1. OnthePhysical GroupspageoftheSystemSetupWizard,underNew

Components,click (Unit Discovery).

2. IntheUnit Discoverydialogbox,entertheIPaddressofthedeviceinthe

IP Address Start boxes.

3. IfyouarespecifyinganIPaddressrange,enterthelastIPaddressofthe

rangeintheIP Address Endboxes.

4. SelectthemanufacturerofthedevicefromtheAdaptordrop-downlist.

Otherwise,usethedefault,VSIP,forVerintedgedevices.

Chapter 3: Configuring the HDR 1800 In Nextiva VMS6.2 and Higher