User guide

Adding the HDR 1800 Using the System

Setup Wizard

RuntheSystemSetupWizardtoaddtheHDR1800totheNextivasystemona

singlesite.UsetheSystemSetupWizardto:

Organizeandconfiguretheaddeddevicesintophysicalandlogicalgroups.

AssignthedevicestoNextivaRecordersandESMServers.

ModifyandremovePhysicalandLogicalGroups.

ViewthecameraandbandwidthloadforeachRecorderServer.

Afterwards,youcanconfigurethephysicalandlogicalsettingsforthedevicein

theSystemComponentsworkspace.

► To add the HDR 1800 using the system setup wizard

1. InControlCenter,opentheSystemSetupWizardbydoinganyofthe

following:

FromtheToolsmenu,clickSystem Setup Wizard.

Click System Components >Devices,thenonthetoolbarclick

(SystemSetupWizard).

Inthestatusbar,clickNew Devices,thenclickintheNew Devices

messageboxthatappearsevery60secondswhenanewdeviceis

discovered.

TheNewDevicescountdisplaysthetotalnumberofallnewlydiscovered

andpartiallydiscovereddevices.Hoveroverthisnumbertoviewthe

numberofthedevicesthatarepartiallydiscoveredandthosethatare

fullydiscovered.

2. OntheWelcomepage,clickNext.

Note

TheWelcomePagemaynotbethefirstpagethatdisplays.Itdependson

themethodyouusedtolaunchtheSystemSetupWizard.

3. OnthePhysical Groupspage,selectaHDR1800fromtheNew

ComponentspaneanddragittothePhysicalGroupsfolder.

4. ClickNext.

5. OntheLogical Groupspage,selecttheHDR1800fromthePhysical

Groups ViewpaneanddragittotheMonitorsfolderintheLogical

Groups Viewpane.

6. ClickNext.

Adding the HDR 1800 Using the System Setup Wizard