User Manual

Important Safeguards — continued

SAVE THESE INSTRUCTIONS

• Use only the power adapter supplied with your lamp. If other power plugs, cords or

connectors are used, damage to your lamp or power adapter may occur.

• Unplug lamp during lightning storms or when unused for long periods of time.

• Protect the power cord from being walked on or pinched, particularly at the plug,

convenience receptacles and where the power cord jack enters the lamp.

• Do not pull the cable of the AC adapter when unplugging it from the outlet to avoid

failure or electric shock.

• Avoid placing the lamp in areas that are dusty, humid/moist, lack ventilation, or are

subject to constant vibration.

• Avoid placing this lamp in areas that are exposed to direct sunlight or close to

heat-radiating products such as heaters.

• Use a quality surge suppressor on all electronic equipment. Voltage variations and

spikes can damage electronic components in any system. A quality suppressor

can eliminate the vast majority of failures attributed to surges. Suppressors may be

purchased at electronics stores.

— continued

CAUTION:

Components

What's Included

• LED lamp

• User manual

• Power adapter

• Allen wrench

• Screw

Assembly Instructions

1. Find the wire on the gooseneck (A) and insert it into the pole (B), then twist the pole

(B) clockwise to connect.

2. Connect the two wires together and insert the pole into the base(C). Tighten the

screw using the supplied allen wrench underneath the base (D) after you make sure

the touch panel is facing the front.

3. Lift the latch (E) to adjust the height of the lamp pole from 0 to 15 inches.

allen wrench

Please keep the locking mechanism

locked until installation completed

Align the pipeline to put back

the inner pole if it falls out

6 7