User's Manual

ManualsBrandsVerilux ManualsIndoor FurnishingVerilux Indoor Furnishings VF03

Model: VF03

Summary of content (12 pages)

PAGE 1
Model: VF03
PAGE 2
Dear Customer, Thank you for purchasing the Verilux Brookfield™ Deluxe Natural Spectrum® Floor Lamp. You have received a quality product, backed by a oneyear limited warranty. As a Verilux customer, your satisfaction means everything to us. We look forward to serving you now and in the future. Many other healthy lighting products are available through our catalog and online. Visit us on the web at www.verilux.
PAGE 3
READ ALL INSTRUCTIONS BEFORE USING Important Safeguards DANGER: • Do not operate this device near a water source to avoid electrocution. WARNING: • Do NOT dismantle. • Do not use with power supply voltage other than 120 VAC. • Do not operate lamp in close proximity to ﬂammable or combustible vapors, such as aerosol spray products, or where oxygen is being administered. • Do not cut or shorten the power cord.
PAGE 4
Getting Started Main Parts & Controls A. B. C. D. E. F. G. H. I. J. K. Optix® Glare Control Filter Switch Lamp Head Swivel Knob Lamp Arm Height Adjusting Collar Upper Shaft Close-up of Lamp Head Lower Shaft Lamp Base Power Cord Power Supply (Ballast) Bulb D A C B E K F A B G I J CAUTION: CAUTION: DO NOT LIFT THE LAMP BY THE LAMP ARM. THE LAMP SHOULD BE LIFTED BY THE VERTICAL SHAFT.
PAGE 5
Assembly Instructions Please Read Operating Instructions Carefully Before Using the Heritage™ Deluxe Natural Spectrum® Floor Lamp: 1. Set lamp base on the floor and insert the lower lamp shaft (G) onto the base and screw clockwise to tighten (Fig.1). 2. Pull the slack of the electrical cord through the lamp base (I). 3. Loosen the height adjusting collar (E) to free lamp arm (D). D E 4. With one hand holding the lamp arm (D), screw the upper shaft (F) onto the lower shaft (G) (see assembly detail below).
PAGE 6
Assembly Instructions — continued 7. Attaching the Optix® glare control filter: • Remove glare control filter from protective plastic bag. Take care to hold filter by the edges only. • Insert tabs on bottom of filter into opening. (Fig. 2) • Press into place using thumb tab. Do not touch or press on the filter material itself. Note: Do not touch material Fig. 2 8. Attach the ballast to the power cord. Use care to align the 4-pin plug properly. DO NOT FORCE.
PAGE 7
Adjusting the Heritage™ Floor Lamp The Heritage Floor Lamp adjusts several ways: D 1. To adjust lamp height – hold upper shaft (F) with one hand, loosen height adjusting collar. Raise or lower lamp arm (D) to desired height. Tighten collar (Fig. 5). Note: Do not stand on cord or otherwise restrict its movement while raising or lowering the height of the lamp. 2. To rotate the lamp head right or left, loosen height adjusting collar, swing lamp arm to desired position. Tighten collar.
PAGE 8
Bulb Replacement Instructions Removal C D 1. Unplug lamp from power source. 2. To access the bulb, remove Optix® glare control filter by depressing the thumb tab and lifting it out. 3. Firmly hold bulb base (B) and pull bulb (C) from the socket (A) in an outward motion (Fig. 9). B Installation 1. Unplug lamp from power source. A 2. Firmly hold base (B) and push bulb (C) into the socket (A). Fig. 9 3.
PAGE 9
Troubleshooting Before requesting service on your Verilux® lamp, please read the following: • Make sure all power connectors, cords and plugs are inserted fully and securely. • Be sure the bulb is securely seated into the socket (see page 8). • Make sure there is power to the wall outlet or try another outlet. PROBLEM Light Won’t Come On CHECK Has the plug come loose? Is the bulb old? SOLUTION Insert plug securely into wall outlet.
PAGE 10
Care and Cleaning Your lamp is made from high quality materials that will last for many years with minimum care. You may want to periodically clean the lamp using a mild non-abrasive cleaner and soft cloth. When cleaning, make sure you have turned off and unplugged the unit and allowed sufficient time for the unit to cool. All liquid should be properly wiped away and dried prior to restoring power. CAUTION: CAUTION: DO NOT USE SOLVENTS OR CLEANERS CONTAINING ABRASIVES, OR AMMONIA BASED CLEANERS.
PAGE 11
One Year Limited Warranty ATTENTION! ONCE OPENED, PLEASE DO NOT RETURN THIS PRODUCT TO THE STORE WHERE IT WAS PURCHASED FOR REPAIR OR REPLACEMENT! Many questions may be answered by visiting www.verilux.com, or you may call our Customer Service Department at 1-800-786-6850 during normal business hours. This limited warranty is provided by: Verilux, Inc.