manual

8
Assembly Instructions — continued
4. Removethelightdiffuserfrom
the protective plastic bag.
Insert the plastic pegs at the
bottom of the light diffuser into
the openings near the bulb
socket. Snap the tab
into place as shown
in Fig. 4.
Note: Be sure all
styrofoam packing
is removed from the bulb
area prior to installing the
light diffuser.
Fig. 4
3. Setthelampbaseonthefloorandinsert
the lamp shaft over the base support unit
until the screw holes line up as shown in
Fig. 3. Insert the screw using the tightening
tool and turn clockwise to tighten.
Close-up of screw hole in
the lamp base
Fig. 3
VF02_MAN_Rev14.indd 8 12/29/11 4:25 PM