manual

7
Assembly Instructions
2. Hold the upper shaft with one hand
and release the ergonomic height
adjustment lever by gently pulling it
upwardasshowninFig.2.Extend
the upper shaft approximately
12".Locktheadjustmentleverby
gentlypushingitdownward.Once
assembly is complete, raise or
lower the upper shaft to the desired
height by releasing and locking the
height adjustment lever.
Fig.2
1. Attach the lamp head gooseneck to
the shaft until the screw holes line up
asshowninFig.1.Usecarewhen
tucking the wire into the shaft. Insert the
screw using the tightening tool and turn
clockwise to tighten.
Close-up of screw hole in
the lamp head
Fig. 1
VF02_MAN_Rev14.indd 7 12/29/11 4:25 PM