Technical data
Verifone Finland
Oy
5
Vantaankoskentie 14 FI-01670 VANTAA | tel: +358 (0)9 477 4330 | fax: +358 (0)9 436 2490
www.verifone.fi
1. BEFORE USE
1.1 Important
NOTE! If these instructions are not followed and the terminal is damaged it will void the
warranty!
• Protect the power cord and modem. If they are damaged they are not to be used anymore.
• The terminal is not waterproof or dustproof, and is intended for indoor use only.
• The warranty of the terminal will void if it is exposed to water or dust.
• Do not use the terminal next to water or moist areas.
• Do not use below 0°C degrees.
• Never place anything inside the chip slot or connection ports that are not meant there. This
might seriously damage the terminal.
• If the terminal is damaged contact Veri’s maintenance service. Never try to fix the terminal
by yourself.
• Use only appropriate paper with the terminal’s printer. Poor quality paper can jam the
printer and create excessive paper dust.
• The terminal should not be connected to the same electrical outlet as a device which is not
using an electrical transformer, or which transformer’s voltage is too high.
• Never use thinner, trichloroethylene, or ketone-based solvents- they may cause
deterioration of plastic or rubber parts. Do not spray cleaners or other solutions directly onto
the keypad.
• Disconnecting the power during a transaction may cause transaction data files not yet
stored in terminal memory to be lost.
1.2 PA-DSS –Standard
The purpose of the PA-DSS –standard is to help software suppliers develop, according to the PCI-
DSS requirements, payment solutions which do not save forbidden card information such as the
CVV2 or the PIN-code.
Companies must use solutions for card payment processing that are approved according to the
PCI-DSS –standard.
For the latest version of the Verifone PA-DSS Implementation Guide, go to
http://www.verifone.fi/manuals