Instruction manual

BOOT MODE FUNCTIONS



1999 LinkPoint International, Inc. 12 LFRST23 Reference Manual
BOOT MODE FUNCTIONS
The LinkPoint 3000 boot mode allows access to certain Operating System, Hardware, and
Diagnostic functions, including: date and time setup, terminal diagnostics, clear memory
(application and data), port setup, and application download. Application download procedures
are covered in detail beginning on page 26. This section explains how to:
1. Set the correct date and time
2. Use terminal diagnostics
3. Setup ports
4. Erase the RAM
!
If the LP2000 displays APP. NOT AVAILABLE on line 1 of the display and TIME LOAD
SETUP on line 2, it is already in boot mode. When in boot mode with an application
already loaded, line 1 displays CLEAR TO RESUME, while the display on line 2 is also
TIME LOAD SETUP.
Boot Mode Passwords
•
If an application is already downloaded into the LinkPoint 3000 terminal (i.e. display reads
READY XXX), the procedure to gain access to the boot mode is:
hold down [ALPHA], press
[7] [1] [3] [9] and release [ALPHA]
.
•
While in the boot mode, if the LP2000 terminal prompts for password entry, key in the
password
[4] [6] [5] [1] [0] [7] [0] and press [ENTER]
.
Cold Boot
The cold boot feature can be used to clear the terminal’s memory (RAM). This feature should
always be used under the guidance of a qualified service representative, and should only be done
to clear a corrupted application or to perform download tests. To access this feature, with the
terminal’s power off, hold down the [CLEAR] key and plug in the power cord:
Display Message Operator Action
Enter password: Key in the default password of [4] [6] [5] [1] [0] [7] [0] or the
password assigned by the bank/ISO or FDMS Help Desk and
[
▲
] [
▲
] [
▲
] press [ENTER].
CLEAR to cold start Press the [CLEAR] key to erase the memory (RAM) or any
Any other to resume other key to reboot the terminal.
[
▲
] [
▲
] [
▲
]
LP-3000,3.
X
,
MMDDYY
Press the [*] key to reset the terminal to the
Select Test Number “App Not Available” display.
[
▲
] [
▲
] [
▲
]