User guide

500-1421E rev1.2 NVeDVR User Guide 3
IR Remote Control
All actions on the front panel can also be done on the remote control.
Index Name Description
1 POWER Turn device on/off
2 DEV Enable/Disable IR remote control
3 Numeric Keys Same as numeric keys of front panel
4 EDIT Same as EDIT key of front panel
5 A Same as F3 key of front panel
6 REC Same as REC key of front panel
7 PLAY Same as PLAY key of front panel
8 INFO Same as INFO key of front panel
9 VOIP Same as [Main/Aux] key of front panel
10 MENU Same as MENU key of front panel
11 PREV Same as PREV key of front panel
12 Direction Keys ENTER
Same as direction keys and enter key
of front panel
13 PTZ Same as PTZ key of front panel
14 ESC Same as ESC key of front panel
15 Reserved Not Used
16 F1 Same as “F1” key of front panel
17 Lens control in PTZ mode IRIS, FOCUS ZOOM for lens control
18 F2
Same as ”F2” key of front panel
IR Remote Control Setup and Configuration
Loading the batteries into the Remote Control
1. Remove the battery cover.
2. Insert the batteries. Make sure the polarity (+ and –) of the batteries is correct.
3. Replace the battery cover.
Using the IR controller
1. Press “DEV”.
2. Input the DVR Device ID (The default is 88).
NOTE: Refer to the Display Menu section to program the Device ID.
3. Press “ENTER”. The STATUS lamp on the DVR front panel will turn on. The Remote Control is now ready to be
used with the DVR.
Turn off the IR Remote Control
While the Remote Control status LED is on, press “DEV”. The STATUS LED will turn off. The Remote Control will no
longer control the DVR.
Trouble Shooting the Remote Control
If the Remote Control does not function correctly;
• Ensure the batteries are installed correctly.
• Replace the batteries with new ones.
• Reprogram the Device ID into the Remote Control.