Installation Manual

Sensor Type 0 1 2
OCC
Occupancy Sensor
Disabled Enabled*
DS
Door Switch
Disabled
N/C
Normally Closed
N/O*
Normally Open
RT
Temperature Sensor
Master*
Temperature Reading From
Sensor Overrides Thermostat
Average
Average of Temperature
Readings From All Sensors
& Thermostat
Average
Average of Tem-
perature Readings
From All Sensors &
Thermostat
30 31
Con guring & Managing Accessories
Discovering an Active Sensor
The thermostat will display the  rst sensor discovered in the pairing process. Ensure
that the unique device number displayed on the screen matches the unique ID found
on the sensor.
➤ Press the F|C button to con gure the discovered sensor.
If the sensor displayed on the screen is not the correct sensor to pair with the HVAC
Controller, use the UP or DOWN buttons to  nd other discovered sensors. To start
over, press the ON/OFF button to exit and refer back to the Accessory Con guration
section of this manual.
Con guring & Managing Accessories
Con guring the Functionality of a Sensor
The user must con gure the type of sensor being paired with the HVAC Controller.
Use the table below to con gure the correct sensor functionality.
➤ Press the F|C button to advance to the next device type;
➤ Press the UP and DOWN buttons to increase or decrease the trailing digit;
➤ Hold the F|C to save sensor settings.
*Indicates default setting.