User's Manual

16 17
Testing the thermostat
Following the thermostat configuration, test if the thermostat is controlling
the PTAC unit.
Press the “Power” button to save the Thermostat Configuration and
start using the thermostat;
Press the “Power” button to turn on the thermostat;
Us the “Up” and “Down” buttons to change the temperature setpoint
above and below the current room temperature to test if the
thermostat initiates heating and cooling - the PTAC unit should turn
heating and air conditioning on and off.
Change the fan speed by touching the “Fan” button to test if the
thermostat is controlling the fan speed.
Thermostat Configuration
Configuring the Energy Saving Settings
Use the “Up” and “Down” buttons to select one of Energy Saving
presets;
0 Energy Savings Off - No Temperature Setback;
1 Lowest Energy Savings;
2 Lower Energy Savings;
3* Standard Energy Savings;
4 Higher Energy Savings;
5 Highest Energy Savings - No temperature control if room is
unoccupied;
Refer to the APPENDIX 1 for Energy Saving Preset details.
Thermostat Configuration