User's Manual

Programming a Thermostat with a Network Programmer

In case of Network Installation with Remote Management, the

thermostat must be programmed with a Network Programmer

speciﬁc to the property before the installation.

Thermostat must not be powered during the programming procedure..

➤ Plug one programmer connector into the thermostat;

➤ Push the black button on the programmer. The red light on the

programmer should turn on and remain steadily lit;

If the red light on the programmer is blinking or is not steadily lit,

unplug the programmer from the thermostat and repeat the steps

above.

➤ Unplug the programmer from the thermostat;

Before You Begin