Models 73010949 / 73010955 73010961 / 73010967 73010973 / 73010979 73010985 / 73010991 73010997 / 73011003 73011009 / 73011015 73012814 / 73012815 Vinyl Fence Assembly and Installation Instructions Owner’s Manual Version 1.0 34106377BOM V1 03/11 PLEASE READ ASSEMBLY INSTRUCTIONS COMPLETELY BEFORE STARTING. ALL STATED SIZES ARE NOMINAL DIMENSIONS. For French and Spanish instructions go to www.barretteoutdoorliving.com.
Thank you for choosing the Barrette Outdoor Living Fence. Please read the instructions completely before assembling your fence. Retain manual and your dated sales slip for future reference and warranty claims. Before You Begin… Check your local zoning laws. • zoning Locallaws and Home Owners Associations may regulate the location, style and height of your fence or even require a permit signoff beforehand. Contact your local utilities companies.
Product Overview: 6’ Models: 73010949 / 73010955 / 73010961 / 73010967 96" Center to Center (5" Posts) 94" Rail Cut Length 5’ Models: 73010973 / 73010979 / 73010985 / 73010991 91" 96" Center to Center (5" Posts) 94" Rail Cut Length 3" 91" 3" 10½" 14" 10½" 14" 72" 43½" 47" 60" 35" 31½" 2" 2" 36" (Recommended) 108" (Recommended) 96" (Recommended) Aluminum Insert Reinforcement 36" (Recommended) Aluminum Insert Reinforcement Wet or Dry Mix Concrete Wet or Dry Mix Concrete 4’ Models: 6
1 Mark the fence location using string and line stakes. 2 Dig post holes 12" in diameter 36" deep. Use the Center to Center measurements of the fence model being installed for the Center to Center Post Distance. If a fence panel is being used that is less than the width of a full panel, or if posts are being used other than 5" in width, measure the width of the panel and add the width of one post, that will be the Center-to-Center post distance of the holes.
5 7 For Build-It-Yourself panel, insert aluminum into bottom rail, then insert bottom rail into bottom post route hole of first post only. 6 Next, attach U-Channels to boards. If assembling Red Cedar panels, you must screw U-Channels to post first and then add boards. Insert boards into bottom rail ensuring U-Channels are on both ends. 8 Add the side channels to the sides and the lattice insert over the top of the lattice. Place into the middle rail followed by the top rail.
9 Finally add the completed assembly into the route holes of the first post. 11 10 Insert the completed fence panel into the route holes of the second fence post. Plumb and level the post and add concrete according to manufacturers instructions. Check to ensure the second Post is level , then measure panel plus add dimensions from center of 2nd post to center of next and dig the third post hole accordingly.
12 13 Repeat process from steps 2 to 9 until all fence panels and posts have been installed. Apply glue on inside rim of post caps then attach to posts.
Transferable Limited Lifetime Warranty What is covered: Barrette Outdoor Living warrants vinyl and aluminum products to include vinyl fence, railing, plastic lattice, trellis, arbors and aluminum fence against defects or workmanship for as long as you own your home. Barrette Outdoor Living will at its option repair or replace the product in question with new product of the same or equivalent value at no charge.
