Installation Guide

3" Support Brace

Assembling rail section:

Lock tabs on balusters/spindles must face outer edge

of routed holes in rails. Assemble your rail section by

snapping balusters/spindles in rails (Fig.1).

a. One support brace is included with 6' railing kits.

b. Two support braces are included with 8' railing kits.

Install support braces evenly across span of railing

section (Fig. 2).

NOTE:

Closely follow post installation instructions

(or sleeve existing wood 4x4).

VINYL RAILING

Fig. 2

Fig. 1

Locking Tab

Cut two 3" temporary wood spacer blocks (not included)

to insert under ends of railing sections to temporarily

assist in aligning railing section (Fig. 3).

Slide two top and bottom rail brackets on ends of

completely built rail sections (Fig. 4 & 5). Slide rail

section in-between posts and on top of temporary wood

spacer blocks (position wood spacer blocks next to

installed vinyl posts) (Fig. 6).

3" Support

Brace

3" Wood

Block

Fig. 3

Fig. 4

Fig. 5

Fig. 6