Instructions / Assembly

3
Assembling rail section:
Lock tabs on balusters/spindles must face outer edge
of routed holes in rails. Assemble your rail section by
snapping balusters/spindles in rails (Fig.1).
a. One support brace is included with 6' railing kits.
Measure equal distance from both ends of railing and
install support brace in center of bottom rail.
For 67
1
⁄
1
⁄
1
2
⁄2⁄
" rail: install center of support brace
33
3
⁄
3
⁄
3
4
⁄4⁄
" from ends of rail (Fig. 2).
b. Two support braces are included with 8' railing kits.
Measure length of rail, divide by 3 and measure that
distance from your rail to the center of your  rst
support brace and install support brace. Repeat that
step from the opposite side of your rail.
For other rail lengths: install support braces evenly.
NOTE:
Closely follow post manufacturer's installation instructions
or use a Post Jacket on an existing wood 4x4.
1
2
VINYL RAILING
Fig. 2
33
3
⁄
3
⁄
3
4
⁄4⁄
"
3" Support
Brace
33
3
⁄
3
⁄
3
4
⁄4⁄
"
Fig. 1
Locking Tab
Cut two 3" temporary wood spacer blocks (not included)
to insert under ends of railing sections to temporarily
assist in aligning railing section (Fig. 3).
Screw in top rail metal brackets to underside of each
end of rail, with #10 x 1
1
⁄
1
⁄
1
4
⁄4⁄
" square drive screw in middle
slot of bracket (Fig. 4). Do not tighten at this time (allows
for adjustment).
Slide the bottom rail bracket over bottom rail on each
end (Fig. 5).
3
4
5
3" Support
Brace
3" Wood
Block
Fig. 3
Fig. 4
Fig. 5