Installation Guide

Installation
1.) Insert aluminum inserts into both gate uprights.
3.) Insert bottom rail into bottom upright route on one side only.
4.) Insert boards starting from left and working right into bottom
rail. Make sure boards with u-channels are on ends of the
gate closest to the uprights.
2.) In the gate kit there will be two boards that are 4
1
⁄
1
⁄
1
8
⁄8⁄
" wide,
make sure these boards are your end boards and add left
and right u-channels onto the ends of these two gate boards.
Make sure one u-channel is on the “groove” side of the board
and one u-channel is on the “tongue” side of the board.
5.) For full privacy gates slide top rail over all boards and insert
top rail into upright route on same side as bottom rail.
For lattice top, open picket top and closed picket top gates
slide middle rail over all boards and insert middle rail into
upright route on same side as bottom rail.
6.) a.) For lattice top gates add side channels onto lattice
panel. Insert lattice panel into the middle rail and
place top rail on top of lattice panel. Insert top rail
into upright route on same side as bottom and
middle rails.
b.) For open picket top gates insert top rail into upright
route on same side as bottom and middle rails. Insert
pickets through top rail into middle rail.
c.) For closed picket top gates insert pickets into middle
rail. Starting on left side and working right, place top
rail onto all pickets. Insert top rail into upright on
same side as bottom and middle rails.
4
Slide second upright onto gates.
a.
b.
b.
c.