Installation Guide

Determine gate opening:

The gate opening should be 2" wider than the gate (X)

for hardware clearance. The hinge kit will support gates

up to 150 pounds and 6'x6

⁄2' (Fig. 1).

a.) Ready-to-assemble gates are available in

predetermined widths.

b.) For select styles, a custom size gate can be

assembled from a ready-to-assemble panel and

the purchase of the gate framing kit.

c.) Pre-built panels can be altered to make custom

gate sizes. Pre-planning prevents cutting down full

board increments (in privacy panels) and ensures

that the pickets are spaced symmetrical on both

sides to accept the gate hardware correctly.

ADDITIONAL INFO:

For pre-built picket panels, a 3

⁄2" hardware clearance is

required and installed without decorative hinge covers

due to space clearance (Fig. 2).

X + 2"

⁄2

in.

clearance

required

Fig. 2

180º

Install the hinge on the rails/gate upright. The gate can

be adjusted to swing 180 degrees with either a manual

or self-closing feature (Fig. 3).

a.) Mark a pilot hole using the hinge and back plate

(34107106) and drill with

⁄4" bit (Fig. 4).

Fig. 3

Upright

Fig. 4

Cut

Fig. 1