Installation Guide

Position the bottom rail

brackets to the ends of the

bottom of the bottom rail

(side opposite the one with

the routed holes.) Screw into

rail with #10 x 1" screws.

NOTE: Within the Pro-

Rail bracket kit (mod-

el#73013131), the two bot-

tom rail brackets are the

larger ones.

Slide balusters into the routed holes of the bottom rail. Lock

tabs on balusters must face the outer edge of routed holes.

a. Measure up 28-7/8" from top of bottom rail and make a mark.

This will be the location of the top of the bracket

b. Using 5/32" drill bit, pre-drill top rail bracket screw holes into

post. Drill through bracket hole, vinyl post jacket, and wood or

steel post and loosely install ﬁ rst #10 x 2-1/2" screw.

c. Repeat drilling process for remaining screws, and tighten

all screws.

Attach top rail to balusters: Begin at one side of rail and align ﬁ rst baluster with the ﬁ rst routed hole on the bottom side of the top rail

and snap top rail into position. Continue down the line of balusters installing balusters into top rail.

Position the top rail brackets at the ends of the

underbelly of the top rail. Screw into rail with

#10 x 1" screws.

Place top rail gaskets at ends of the installed top rail, if

desired, to cover any gaps created during installation.

Slide bottom rail in between posts and rest on top of wood

spacer blocks.

Screw bottom rail brackets into post (routed hole side of rail,

facing upwards) with #10 x 1" screws.

Place bottom rail gaskets at ends of the installed bottom rail

if desired, to cover any gaps created during installation.

Remove/discard the temporary spacer blocks.

Install Bottom Rails

Install Balusters

Install Top Rail Brackets to Post

Install Top Rail

Install Bottom Rails

/8/