Installation Guide

ManualsBrandsVeranda ManualsLumber & Composites8 ft. x 36 in. Vinyl White Williamsburg Rail Kit with Colonial Spindles

Railing and

Stair Railing Kit

ssembly and Installation Instructions

PLEASE READ OWNER'S MANUAL COMPLETELY

BEFORE ASSEMBLING YOUR RAIL OR STAIR KIT.

34106878BOM V2 5/13

Traditional and Williamburg

Vinyl Railing & Stair Railing Kits

Traditional and Williamburg

Vinyl Railing & Stair Railing Kits

Traditional and Williamburg

To register your product, please visit: www.barretteoutdoorliving.com/product-registration

73003989 / 73003988 / 73003565 / 73003987

Models

Owner's Manual

Version

2.0

Summary of content (6 pages)

PAGE 1
Railing and Stair Railing Kit Assembly and Installation Instructions PLEASE READ OWNER'S MANUAL COMPLETELY BEFORE ASSEMBLING YOUR RAIL OR STAIR KIT. Traditional and Williamburg Vinyl Railing & Stair Railing Kits To register your product, please visit: www.barretteoutdoorliving.com/product-registration 34106878BOM V2 5/13 Models 73003989 / 73003988 / 73003565 / 73003987 Owner's Manual Version 2.
PAGE 2
Thank you for choosing the Barrette Outdoor Living Rail or Stair Rail Kit. Please read the instructions completely before assembling your rail. Retain manual and your dated sales slip for future reference and warranty claims. Before You Begin… Make sure your project meets local building codes before beginning installation.
PAGE 3
For Vinyl Railing Installation: 1 2 Closely follow post installation instructions (or sleeve existing wood 4x4). Assembling rail section: • Lock tabs on baluster/spindle must face outer edge of routed holes in rails • Assemble your rail section by snapping balusters/spindles in rails a. 1 support brace is included with 6' railing kits.
PAGE 4
For Vinyl Stair Railing Installation: 1 2 3 65 3⁄4" max between posts Closely follow post installation instructions (or sleeve existing wood 4x4). Mount top post 1" back from edge of landing. Mount bottom stair post 1" back from stair tread nose. Distance between posts should not exceed 65 3⁄4 . Lock tabs on baluster/spindle must face outer edge of routed holes in rails as shown (Fig A). Assemble your rail section by snapping balusters/spindles in rails (Fig B). a. b.
PAGE 5
7 8 Remove clamped stair kit from posts. Locate previous marked rails and add 1" to your pre-determined measurement (Fig A). Cut all four 1" marks on rails at 90 degrees (Fig B). Note: There is a separate screw pack for the top rail brackets and the bottom rail brackets. a. b. a. b. c. d. a. Slide your angle brackets top/bottom onto your rails and place stair rail section between your posts. b. Determine desired rail height and mark all bracket holes. c.
PAGE 6
Transferable Limited Lifetime Warranty What is covered: Barrette Outdoor Living warrants vinyl and aluminum products to include; vinyl and aluminum fence, vinyl and aluminum railing and plastic lattice against defects or workmanship for as long as you own your home. Barrette Outdoor Living will at its option replace the product in question with new product of the same or equivalent value at no charge.