Installation Guide

9
After posts have been installed, determine angle and
height of railing (Fig. 1).
Pre-drill
1
⁄
1
⁄
1
8
⁄8⁄
" diameter holes in base of top bracket only.
Then, fasten bracket to base at the determined angle
with two #10 x 1" square drive screws (Fig. 2).
Cut railing to desired length. Place bracket on each end
of top and bottom rails (Fig. 3). Fasten bottom bracket to
base with one #10 x 1" square drive screw.
a. Position the rail section between the posts (Fig. 4).
b. Mark four screw hole locations on each bracket. Set
rail section aside, then pre-drill
1
⁄
1
⁄
1
8
⁄8⁄
" diameter holes in
post at each mark (Fig. 5).
1
2
3
4
Fig. 1
Fig. 4
Fig. 5
ANGLE BRACKETS
Determine
Angle
Top View
Fig. 2
#10 x 1" Screws
Fig. 3
Top Rail
Top Rail
Top Rail
Bottom
Rail
Mark Holes
Mark Holes
Top View