Instructions / Assembly

Using the Slidelock™ bracket with the Veranda Windham Panel
NOTICE:
• DO NOT attempt to assemble the kit if
parts are missing or damaged.
• DO NOT return the product to the store,
for assistance or replacement parts call:
1-800-336-2383.
WARNING:
• Improper installation of this product can
result in personal injury. Always wear
safety goggles when cutting, drilling and
assembling the product.
• Incorrect installation may cause harm to
the panel, bracket or individual.
• Not pool code approved.
TOOLS NEEDED:
Vinyl Fence Panels
Vinyl Fence Posts
Safety Glasses
Level
Tape Measure
Drill & Drill Bits
Pencil
Rubber Mallet
COMPONENT LIST:
QTY Description
2 Brackets
2 Bracket Dovetails
6 #10 x 1" Flat Head Screws
1 Template
4 Pan Head Screws
Brackets
Dovetail
Template
Screws
Pan Head Screws
Dovetail
Follow Veranda vinyl fence panel
instructions to mark dovetail position on
posts (g. 1).
2
1
Place bracket inside the rails of the panel
until ush (g. 3). If needed, tap with a
rubber mallet.
TIP: For fence rails that contain an insert,
ensure the inserts are pushed toward
center of rail and bracket ngers slide
behind them.
3
Place bottom of dovetail at marked point
and attach with three #10 x 1" at head
screws (g. 2). Adjust as needed.
Fig. 1
Vinyl Post
Fig. 2
Vinyl Post
Fig. 3
Repeat previous steps for all brackets.
Place panel assembly above the dovetails,
and lower the brackets onto the dovetails
until snug (Fig. 4). Dovetails should not be
visible once installed properly.
Align template to bracket (Fig. 5). Mark
screw hole locations and pre-drill screw
holes using a
1
⁄16" drill bit. Remove template
and install pan head screws into one side
of bracket only.
TEMPLATE BELOW PRINTED TO SCALE
PLEASE CUT OUT AND USE TO
DETERMINE SCREW HOLE LOCATIONS
4
5
Fig. 4
Fig. 5
Screw
Hole
Locations
Template
8196 3/15