Instructions / Assembly

©2016 Universal Forest Products, Inc. All rights reserved.
68956 U.S. Hwy 131, White Pigeon, MI 49099 1-855-556-1852 8724_3/16
www.ufpi.com
STEP 1
Lay all gate components out on a flat, clean surface. Reassemble
the panel by inserting the pickets into the top and bottom rails.
Ensure that all rails are flush with the pickets.
STEP 2
Slide the gate jamb onto the fence panel and place the hinges at
the center of the fence rail. Using the hinge as a guide, drill the four
(4) necessary ¼" holes for the hinge bolts. Ensure the rails are fully
inserted in the jamb before drilling. The bolts need to go through the
jamb and rail to function properly. See Fig. 3
STEP 3
Insert the bolts and loosely attach the nuts (these will be tightened
later). Duplicate for each of the four corners. Once all corners are
loosely fastened, measure from corner-to-corner to ensure the gate
is square. When square, tighten all bolts with a 7/16" wrench. Do not
over-tighten as it may crush the gate jambs. See fig. 3.
STEP 1
Measure to be sure you can install the gate to the post with
approximately a 2" gap from the ground to the bottom of
the panel. Align the rails on the gate to the rails on the fence
panels.
STEP 2
Hang the gate between the posts. Use a 5/8" spacer between
the gate and the posts. See fig. 4. Secure in place with shims
under the gate or clamp the jamb on the gate to the post.
Make sure the gate is level and square. Attach hinge brackets
to the gate post with the provided screws. See fig. 5.
STEP 3
Remove any clamps and shims. Attach latch using screws
provided. See fig. 6.
STEP 4
Install a post cap on each post using PVC cement or an
exterior adhesive.
Note: The gate latch is designed to be used on the left-
or right-hand side of the gate, depending on customer
preference or design. The latch is assembled, ready
to be installed on the right-hand side of the gate. If you
desire to switch the latch, follow these simple steps:
• Remove the 2 shoulder bolts and spring.
• Change orientation of the clicker.
• Re-attach spring and insert shoulder bolts.
• Shoulder bolts must be fully tightened.
Thread locking adhesive is recommended.
VINYL FENCE GATE KIT ASSEMBLY INSTRUCTIONS
FOR DOVER AND OVERLAND PANELS CONTINUED
Assembling the gate
Installing gate
5/8
Fig.4 DoverGateSpacer.ai
Latch
Striker
Fig.6 DoverLatch.ai
fig. 3
fig. 4
fig. 6fig. 5