User manual

Operation Modes
The Operation Mode lets you to define the control mode ViewFlex Device
Driver is running in:
On-Line
On-Line mode the ViewFlex Device Driver waits for the commands from
the OpenCIM Manager, and then Snap, Load Script, Execute Program
Script, and Send Results.
Manual
Manual Mode allows you to test the OpenCIM Manager and manually
simulate conditions of Fail and Pass.
The following are activated only in Manual Mode, after a request from the
OpenCIM Manager:
Send Pass
Sends pass to the Manager.
Send Fail
Sends fail to the Manager.
Simulation
Simulation Mode allows you to simulate test results by determining the
Pass/Fail according to the percentage of failure that was input to the
OpenCIM Manager.
Debug
The Debug Mode allows you to debug every step of the script. This is
made for testing the script before it will be run online.
The following are activated only in Debug mode:
Open File lets you load the script.
Run Script icon executes the script that has been chosen.
Step-By-Step icon lets you to execute each command line of the script
individually.
ViewFlex v.3.3 2-35 User Manual
1209