User manual

6. Click the ROI (Region of Interest) icon, and outline the perimeter of
the cube that was set.
7. Click the Pattern Matching icon.
Pattern Matching Model dialog box
 From the Dimension tab, you will see the cube that was
outlined using the ROI icon.
 From the Search tab, click All.
 From the Angle tab, check Enable Search With Rotate. Then
enter 180 for Delta Negative, and 180 for Delta Positive (this
enables a full 360-degree search).
 Click Search. This will build a Measurement Table containing
all the positions of the object relative to Pos 1.
Measurement Table
ViewFlex v.3.3 2-29 User Manual
1209