User manual

Camera Installation
After installing the ViewFlex software the next step is to install the
camera.
Installing the Veo Camera (Windows XP/Vista/7 32 bit OS versions
only)
Installing the Veo Software
Follow the steps below to install the Veo software. For additional details
refer to the Veo Velocity Connect User's Guide provided with the camera.
For Vista/Windows 7, the camera must be attached to the computer before
installing ViewFlex.
For Windows XP:
1. Insert the Veo Velocity Connect Installation CD-ROM into your
CD-ROM drive.
2. The Velocity Connect installation screen is displayed. Click Install
and follow the directions on your screen to complete the installation
and refer to the Veo Velocity Connect User's Guide for further details.
For Vista/Windows 7:
(For installing the Veo Software only (without the driver)):
Browse the Veo CD to VeoCreativeStudio\setup.exe
For Windows Vista/Windows 7
1. Insert ViewFlex CD.
2. Browse to Windows: drivers\VISTA_Windows 7
3. Launch the file VeoVista7Driver.exe
Connecting the Camera to the Computer
After installing the Veo camera software, the next step is to connect the
camera to your computer (Windows XP only. in Windows Vista/Windows
7 the camera should have been attached before installation of the
software). You must ensure that the camera's lens cover is open.
To connect the camera to the computer, plug the USB Connector into any
available USB 2.0 port on your computer. A window should appear and
recognize a new device being installed. Once it has been installed, in order
to use the camera, it must be connected to the same USB port it was
installed on.
ViewFlex v.3.3 1-10 User Manual
1209