User manual

20. The installation is complete.
Select Yes, I want to restart my computer now.
21. Click Finish. The computer will restart.
22. Plug the software protection key into the USB port of your computer.
Note:
If you receive the message: "Could not start ViewFlex” message, perform
the following:
1. Go to Start I Program Files
2. Select Matrox Inspector and right click
3. Select Run as Administrator
4. Wait till Matrox Inspector loads.
5. Close Matrox.
6. Run ViewFlex again.
ViewFlex v.3.3 1-9 User Manual
1209