User guide

I submerged my pump in water
Your pump is designed to resist accidental contact with water. Do not submerge in water during bathing,
swimming, or other water activities.
1 Pat the outside of the case until dry.
2 Open the reservoir compartment and check the compartment and reservoir for water. If wet, dry it
completely within 10 minutes of exposure to water. Exposure to liquids, including water or insulin can
corrode the mechanism.
3 Dry the reservoir completely—do NOT place a wet reservoir in the pump.
4 Do not use hot air to dry your pump. This may damage your pump's internal electronics.
5 Check the battery compartment and the battery—if wet, let them dry completely before using the pump.
6 Perform a selftest.
I cannot get to the USER SETTINGS screen
If you press ACT when you have User Settings highlighted, the following message appears: This feature is
not normally accessible. To access, consult your User Guide.
To get to the USER SETTINGS screen:
1 Go to the UTILITIES MENU screen.
Main > Utilities
2 Select User Settings. Hold down
and press ACT.
3 See the User settings section in the Utilities chapter for information about the menu options.
Alerts
Your pump has a sophisticated network of safety checks and systems.
If it detects an unusual condition that requires your immediate
attention, it beeps or vibrates periodically to alert you. The pump goes
into Special mode (an open circle displays), and the backlight
illuminates.
Question: Why are alerts important?
Troubleshooting, alerts and alarms 177
Chapter 13