User guide

Turn on remote control option
WARNING: If there is a LOW BATTERY condition, the pump will not receive signals from the remote. To
ensure the pump communicates with the remote control, make sure the pump does not have a low
battery. (Replacing the low battery with a new battery will restore remote control function.)
1 Go to the REMOTE OPTION screen.
Main > Utilities > Connect Devices > Remotes
2 Select On, then press ACT.
3 The REMOTE ID MENU screen appears. Add, delete or review your remote ID as described in the next
section. Exit the menus if you are done.
Add, delete, review remote control IDs
Each remote control has its own unique ID. Up to three different remote control IDs can be programmed in
your pump. You must turn on the remote option to add, delete or review the remote control IDs programmed
in your pump.
1 Adding a remote ID
a. Select Add ID from the REMOTE ID MENU screen, then press ACT.
b. Enter each of the six ID numbers found on the back of the remote control. Press ACT after each
entry. After you set the last number of the ID, the screen will return to the REMOTE ID MENU.
2 Deleting a remote ID
a. Select Delete ID from the REMOTE ID MENU screen, then press ACT.
b. Select the remote ID that you want to delete, then press ACT. The selected ID is now deleted.
3 Reviewing remote IDs
a. Select Review ID from the REMOTE ID MENU screen, then press ACT.
b. The programmed IDs will show in the REVIEW REMOTE ID screen.
4 Exit the menus when you are done.
Other Devices option
The factory setting for this feature is Off.
Other devices may be available to be linked to your pump. If available, refer to the appropriate device user
guide for programming and operating instructions.
Utilities 163
Chapter 10