User guide

Disconnecting the transmitter and removing the sensor
Disconnecting the sensor from the transmitter
If you are not going to replace the sensor, turn the Sensor features Off to avoid getting a LOST SENSOR alert.
1 Carefully remove any occlusive dressing from the transmitter and sensor.
2 For the Enlite sensor, remove the adhesive tab from the transmitter.
3 Hold the transmitter as shown, and pinch the flexible side arms of the sensor between your thumb and
forefinger.
4 Gently pull the transmitter away from the sensor.
Removing the sensor
Gently pull the sensor from your body to remove it. Place it in a sharps container.
Storage
If you do not plan to use your transmitter in the next 30 days, connect it to the charger for storage.
Using your system in water
Your pump must not be used in water and needs to be removed if planning water activities.
You should shower, bathe and swim with the transmitter and the sensor by following the guidelines
below:
1 Disconnect the infusion set from the pump and remove the pump. The pump is not water-tight.
2 After the transmitter and sensor are connected, they form a water-tight seal to a depth of 2.4 meters
(8 feet) for up to 30 minutes. You can shower and swim without removing them. Avoid taking hot baths
as this may significantly reduce the sensor's life.
Using your sensor 151
Chapter 9